Appliances to fit this unit:
With new extra wrap around tambour on tall rear unit
- Side unit with 9 doors & 2 drawers
- Sliding tambour door
- Over bed locker for low roof and elevating roof vans
- Front bed panel with door and rear bed panel
- 2 drawers one for cutlery and the other extra deep 150mm high
- Concealed self close hinges with flush fitting doors
- Table with folding aluminium leg and stainless steel sliding rail system
- All connecting blocks, hinges, grey or silver edging, push catches and screws
- The front cupboard door unclips to fit a Waeco CR50, CR40 or Vitrifrigo C51I fridge if you wish to install one later.
- Knock on edging for all exposed edges, the edges are pre slot cut for you to apply
- Designed to be easy to construct with easy mount hinges, slots for aligning the panels and pre drilled hole for the connector blocks
- The worktop cut for a SMEV 9222 sink hob ( righthand sink ) [ 9722 requires drawer back to be trimmed ]
- Available in a range of own light weight ply finishes
- Worktop and Table can be a different finish.
- Edging: Silver, dark grey , black
- Works with Reimo Variotech 3000 1155mm, Scopema RIB seat 1120mm wide sliding version, BEBB seat, Smart beds Evolution and various rock n roll beds 44” wide or less. Type 2 maximum bed length is 1940mm measured from the back doors ( see diagram )
- Works with both low roof and elevating roof conversions
- Please note the EVO 1.5 kit does not work with a fixed RIB bed, if you would like to use a fixed RIB bed please see EVO 4 kit.
Flat pack kit for DIY construction designed for the short wheel base Vw T5 transporter panel van. Select the finishes you want and the bed / roof type you have.