Can be used on both Crafter and Sprinter vans.

Opening size is 1054 x 485 ** check dimensions will work before purchasing ** These can not be  returned if you have cut them down the best way to cut them is either with a fine metal jigsaw blade or an angle grinder with a thin metal cutting disc.

Can be purchased with a pre cut ply panel designed to accept panel clips to hold the fibre glass and ply together.

**Important check how your bed frame sits in your van and  will it allow the the trim ring to fit. Our own bed ply bed platform  can be modified to work by cutting the top panels and cross members down , we will be selling  a version designed specifically to work with the trim rings. If you have an existing bed platform purchased from us ( Pre January  2023) please be aware this will not work without modification.

Watch the videos before purchasing., here is an excellent video made by Urban ark overland please note our trim rings are a different shape and size the but the principles are the same: <strong><a href=”https://www.youtube.com/watch?v=awDjpsDf3Vg”>HERE</a></strong>

Note – The Trim Rings do not fit the LWB or XLWB Sprinter, even the smaller one is approximately 30mm too wide. 

&nbsp;

Can be used on both Crafter and Sprinter vans.

Opening size is 1054 x 485 mm ** check dimensions will work before purchasing ** These can not be returned if you have cut them down the best way to cut them is either with a fine metal jigsaw blade or an angle grinder with a thin metal cutting disc.

Can be purchased with a pre cut ply panel designed to accept panel clips to hold the fibre glass and ply together.

**Important check how your bed frame sits in your van and  will it allow the the trim ring to fit. Our own bed ply bed platform  can be modified to work by cutting the top panels and cross members down , we will be selling  a version designed specifically to work with the trim rings. If you have an existing bed platform purchased from us ( Pre January  2023) please be aware this will not work without modification.

Watch the videos before purchasing., here is an excellent video made by Urban ark overland please note our trim rings are a different shape and size the but the principles are the same: HERE

Space Pod Fitting Instructions                                           

• Check Fit Before Permanent Changes:
• Ensure the Space Pod fits properly before gluing, painting, or sanding. Return the pod in its original box for a full refund if unsatisfied. No refunds will be given if the pod is glued, painted, or wrapped.
• Preparation:
  • If painting, avoid low baking or heating the pod to prevent distortion.
  • Ideally, paint the pods after fitting.
• Surface Keying:
  • Key the surface of the van with wet and dry and the Space Pod with 120 grit sandpaper.
  • Sand down any high points on the Space Pod back surface.
  • Do not use etching primer paint on the Space Pod; use only sandpaper for keying where adhesive will be in contact.
• Adhesive Application:
  • Apply polyurethane adhesive to the van in a constant bead around the sides and top of the pod to prevent leaks.
  • Cut a “V” shape in the nozzle for a higher adhesive bead.
  • Use 1.5 tubes of Sikaflex 252 or similar adhesive per Space Pod.
• Bonding Process:
  • Bond the pod in place; use masking tape and wedges to help hold the position.
  • Place a ratchet strap or similiar around the van body and the Space Pod to apply light pressure.
  • Use foam blocks under the straps in specific places to push the Space Pod if necessary.
• Adhesive Cleanup:
  • Clean off any excess adhesive before it sets; tar and oil remover works well.
• Final Touch:
  • Once bonded, apply a bead of adhesive along the front edge of the pod to finish.
  • Link to video here